Raco Guard-It Especificações descarregar pdf (Página 7)

Installation

Guard-It

Owner's Manual 2-1

2 Installation

2.1 Mounting Location

Ideally, the Guard-It

autodialer and the wiring connected to it should be

located away from heavy duty power wiring and wiring which is likely to emit

substantial electrical interference. The location must be free of condensing

moisture, and must remain within a temperature range of 20 to 120 degrees F

for proper operation. Allow clearance room for the plug-on connector block

and phone line connectors at the bottom.

The product should be located within 5 feet of an RJ11 telephone line jack,

otherwise a telephone extension cord will be needed to make the phone line

connection.

If you are using the optional 12 VDC wall adaptor to power the product, you

will need a 120 VAC electrical outlet to plug the adaptor into. The product

should be located within five feet of this outlet; otherwise it may be necessary

to splice in additional wire length for the 12 VDC line.

2.2 Mounting Onto A Back Surface

Referring to the diagram, attach the mounting brackets to the product. Prepare

the back surface by drilling pilot or clearance holes for the mounting screws.

The mounting centers are 3.6" high by 9" wide. #8 Wood screws, self tapping

screws and machine screws (with lock washers and nuts) are provided to

accommodate a variety of back panel materials. Refer to the diagram (See

Appendix F).

2.3 Mounting Flush Into A Front Panel

To mount the product flush into a larger front panel (maximum panel thickness

1/8"), you will need a rectangular cutout in the panel to clear 6-3/16" high by 8-

3/16" wide. Slide the product into the opening from the front, and use the 6-32

screws to attach the two mounting brackets to the product in the proper

orientation so that they hold the product firmly in place against the larger front

panel. Refer to the diagram (See Appendix F).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Sem comentários

Raco Guard-It Especificações Página 7